HOME

About Motion-automation

About Quik-tool

Why Quik-tool

Quik-tool systems

Contact

News

DE

EN

NL

Quik-tool systems

Quik systems can be adapted to all circuit board support heights in a wide variety of stencil printers, SMT placement machines or AOI/SPI machines from a minimum of 39mm up to 169mm.

 

Quik-tool modules always have an HD grid of 12x18mm with a module width of 32mm and are available in different module lengths of 305mm, 381mm, 457mm or 533mm.

Complete systems always with controller, power supply, air distribution manifold and trigger signal sensor (e.g. optosensor)

 

 

Quik-tool – the advantages at a glance

  • Largest underside component clearance for assembled components up to 27mm (QTZ series, from 66mm PCB support height)
  • Lowest pin pressure of only 2.5 g due to the enlarged surface of the pins
  • Highest holding force of the locked pins of 2,000g through innovative clamping of the pins
  • New design of the ESD compliant rubber caps (same as pin size) for faster module maintenance
  • Automatic mode with its own trigger signal sensor or manual mode freely selectable at any time
  • OPTIFLOW automatic air volume control – adding or removing modules when changing products WITHOUT the operator having to readjust the air volume on the air distribution manifold
  • Reliable pin reset due to the higher weight of the polished stainless steel pins
  • Pin locking is completely isolated from the pin guidance for extreme reduction from wear and tear

Quik-tool – Deliverable complete systems

Quik-tool systems have been used successfully by our customers for years, for example at these machine manufacturers: ASM (DEK), Assembleon, Dima, EKRA, ERSA, Essemtec, Europlacer, Fuji, I-Pulse, Juki (GKG), Koh Young, Mimot, MPM Speedline, Panasonic, Samsung, SJ Innotech, Sony, Speedprint, Universal, Viscom, Yamaha and many more

©2023 Motion-automation

Site Notice

Privacy Policy

Webdesign: nexsign Werbeagentur